MNTeggy
Senior Member
Yeah, that board is cool! Snowboardingβs fun too!No sir! Just like cool stuff. I do snowboard though
Sponsored
Yeah, that board is cool! Snowboardingβs fun too!No sir! Just like cool stuff. I do snowboard though
This man has exceptional tasteAPR GT mirrors and Spoon floor braces installed a few days ago.
![]()
![]()
![]()
![]()
![]()
![]()
Wow. Those mirrors look weird as hell. But then U actually see them mounted and itβs a dope ass look! Grats bro. Looks killer!APR GT mirrors and Spoon floor braces installed a few days ago.
![]()
![]()
![]()
![]()
![]()
![]()
Mirrors look better in person than pictures IMO and goes well with the rest of the APR kit.Wow. Those mirrors look weird as hell. But then U actually see them mounted and itβs a dope ass look! Grats bro. Looks killer!
thoughts on the floor brace? Would U say itβs kinda owo or full on UWU?
APR GT mirrors and Spoon floor braces installed a few days ago.
![]()
![]()
![]()
![]()
![]()
![]()
Suppose to increase rigidity. I havenβt really pushed it yet due to bad weather so I canβt say how much I can feel the braces. They have harness points as well, so I may install a bucket seat and harness bar in the futureCurious what the floor braces do and if you can feel any improvements.
GYATT!!APR GT mirrors and Spoon floor braces installed a few days ago.
![]()
![]()
![]()
![]()
![]()
![]()
Dang that looks nice! Just ordered the "aggressive" style. Wish I would have gotten the low profile!Just installed the carbon spoiler from Extreme Online. Loving the look of it so much more than stock. Installation wasnt too bad following a video on Youtube. The carbon really pops![]()
![]()
![]()
I would recommend getting wide and decently thick m6 washers since the holes are square. The double sided tape it comes with didnt look very good so i used 3M VHB double sided along with window sealant tape to cover the middle holeDang that looks nice! Just ordered the "aggressive" style. Wish I would have gotten the low profile!
I also used little squares of VHB tape I cut to cover the square holes, and only used the round holes at the very ends to secure the spoiler (to pull it "down" to match the curve of the trunk). The rest of the bolts are really not needed.I would recommend getting wide and decently thick m6 washers since the holes are square. The double sided tape it comes with didnt look very good so i used 3M VHB double sided along with window sealant tape to cover the middle hole