I wish they'd give us the HRC lip or at the very least, the anime car lip!Saw this on AFDs IG. Looks exactly like the one EOS sells.
APR, RSplitters & Artwork are the only ones that look good. Everything else has too much going on.I wish they'd give us the HRC lip or at the very least, the anime car lip!
I had similar feelings about the jogon front because it looked TOO aggressive below side ventsI have the Jogon sitting in the box and I'm VERY hesitant to run it because the sides are a bit too aggressive for my liking. I was hoping the pictures were just exaggerating the profile but it is really bad in real life too.
The only reason I'm still holding on to the Jogon is because I'm waiting on a release of a kit from a new, unnamed supplier which hasn't made their announcement yet. From the prototype pictures, it looks like I *might* be able to mix and match the Jogon pieces with their new pieces.
I've said too much.
Yea…. About that….. so the install hardware they provide are these rubber rivet nuts. It does a great job at holding the lip on there, but at highway speeds it starts to pull down or sag. I guess it’s working as intended. lol. Needless to say, I fought with it for about 3 months and stressed on every drive. What I ended up doing is removing the bumper and getting some nuts, bolts and washers. I cut the threaded part of the rubber rivet nut off, and used that to center the bolts through the holes. I mounted using the hardware I purchased and that bitch ain’t moving
. The side splitters and rear spats use actual nuts and bolts so those are good to go, it was jus the front lip I had do a modified install.
Sweet deal. Thanks man
are we all pretty sold on PRL? How do we feel about 27Won. Never ordered anything from eitherYeah that’s what I’m worried about regarding that front lip, it looks badass but don’t need it flying off while on the freeway!!! May try another brand, are there any that people aren’t having issues with?Yea…. About that….. so the install hardware they provide are these rubber rivet nuts. It does a great job at holding the lip on there, but at highway speeds it starts to pull down or sag. I guess it’s working as intended. lol. Needless to say, I fought with it for about 3 months and stressed on every drive. What I ended up doing is removing the bumper and getting some nuts, bolts and washers. I cut the threaded part of the rubber rivet nut off, and used that to center the bolts through the holes. I mounted using the hardware I purchased and that bitch ain’t moving
We shall never see the likes of him again....I have the Jogon sitting in the box and I'm VERY hesitant to run it because the sides are a bit too aggressive for my liking. I was hoping the pictures were just exaggerating the profile but it is really bad in real life too.
The only reason I'm still holding on to the Jogon is because I'm waiting on a release of a kit from a new, unnamed supplier which hasn't made their announcement yet. From the prototype pictures, it looks like I *might* be able to mix and match the Jogon pieces with their new pieces.
I've said too much.
I'd say the PRL is the better design with the EPDM molded rubber vs sleeved design of the 27won which is more likely to degrade faster.Sweet deal. Thanks man
Had both PRL and Wunderladen and strongly prefer the Wunderladen.Sweet deal. Thanks man
Outcome: significant narrowing of the range of drone, now centered at 3k. Drone sound level reduced by about 50% but not eliminated. I may replace the vibrant 5" diameter bottle resonator with a second 1142 after thanksgiving, which should further reduce low frequencies while bringing back some higher frequencies, which is a sound profile I prefer.
Good to know thank you for that technical knowledge. PRL it is
