Did you mean in general? We have to get the accessory heated wheel which has the heating elements built in but it also comes with the button, harnesses, fuse, and rear shroud to accomodate the button.
Got it. I didn’t read the previous comments and I just saw the heating button on the Mugen wheel.
There is a heated wire that runs in the wheel itself. Need the button and wiring. Not sure what you need since my Canadian spec car came with the heated wheel.
Hey, Can you elaborate on how you handled the mud flap thing? I've been wanting these but don't want to lose the mudflaps. I know another member did it too but just wondering exactly how to measure and cut, etc.Here’s a better pic
Used a jigsaw to cut them. I actually have the pieces that I cut. I s'pose I could somehow scan it and make a PDF folks could print out and use to cut. I did the fronts nearly perfectly so the pieces are good, the rear, i cut a bit more off than I wanted, but still looks good. I guess i could remove that, and scan that and make a template. It will at least be a good starting point referencing the pics I took. When I was doing this, I wished there was some sort of template.... If there is enough interest, i may do it for folks.
Jigsaw. Hmm, sounds like it wasn't too hard. Once you cut the edge, did you paint it? What did the unfinished edge look like? Their stuff does seem pretty sturdy so I imagine it wouldn't hurt anything. I want a template! Looks good though.Used a jigsaw to cut them. I actually have the pieces that I cut. I s'pose I could somehow scan it and make a PDF folks could print out and use to cut. I did the fronts nearly perfectly so the pieces are good, the rear, i cut a bit more off than I wanted, but still looks good. I guess i could remove that, and scan that and make a template. It will at least be a good starting point referencing the pics I took. When I was doing this, I wished there was some sort of template.... If there is enough interest, i may do it for folks.
here's the front and rear close up:
No I didn’t paint it, I just sanded it down and made it smooth enough. The unfinished edge is just a matte black and doesn’t look out of place. I’ll see if I can get a template for ya next week when I can have access to a copier/scanner
Don't spend too much time on it but thank you. I can probably trace my mud flap too and sort of figure it out. I'm not sure there will be a huge demand for the template. I still have to actually order them. Ha ha.
Could you mock up with carboard? Cheap and easy.
If you think that's work, you should see how people custom mock fenders to make them right, lol.
