What did you do to your Integra Type S today? 🙋🏻‍♂️

[ABPDE5]

As a side project, I've started working on a new belly pan that has additional naca ducts for getting some air into targeted areas as well as getting hot air out.

I decided to make it out of carbon since aluminum and plastic both have their own issues. For the naca ducts, I'm going to mold them up with a 3d printed mold. Should be fun!

Photo of the in progress print and a smaller test print.

Do you print at home? Or send the design out?

Sponsored

 

[Victorofhavoc]

Do you print at home? Or send the design out?

Printing at home. Sending it out is too time-costly.

 

[UWU-mancer]

As a side project, I've started working on a new belly pan that has additional naca ducts for getting some air into targeted areas as well as getting hot air out.

I decided to make it out of carbon since aluminum and plastic both have their own issues. For the naca ducts, I'm going to mold them up with a 3d printed mold. Should be fun!

Photo of the in progress print and a smaller test print.

Can’t wait to see the end result!

 

[Victorofhavoc]

One full size duct mold printed! Now I just have to sand, polish, ceramic coat, and wax prior to carbon layup.

Sponsored