kiralex
New Member
- Thread starter
- #1
Last month I traded in my 25 A-Spec for a 24 Type-S. When I initially purchased the car, everything was functioning properly. However, after about a week of ownership, the HUD suddenly stopped displaying correctly. I parked the car one evening with the HUD working normally, and when I started it the next morning, the HUD no longer appeared in my normal line of sight.
I can still see the HUD projecting if I look at an extremely sharp angle (ducking down below the steering wheel), and it's displaying accurate real-time information at that angle. I've already tried adjusting the height settings through the full range, changing brightness levels, and toggling the HUD on/off, but none of these made any difference.
Based on how it's behaving, it appears the HUD projector is aimed at an incorrect angle or the internal mechanism has shifted position.
Has anyone experienced this with their Type-S? Can anyone confirm if this would be covered under the original factory warranty? I'd prefer to try any remaining troubleshooting steps before scheduling dealer service if there's anything else worth attempting.
Thanks in advance!
I can still see the HUD projecting if I look at an extremely sharp angle (ducking down below the steering wheel), and it's displaying accurate real-time information at that angle. I've already tried adjusting the height settings through the full range, changing brightness levels, and toggling the HUD on/off, but none of these made any difference.
Based on how it's behaving, it appears the HUD projector is aimed at an incorrect angle or the internal mechanism has shifted position.
Has anyone experienced this with their Type-S? Can anyone confirm if this would be covered under the original factory warranty? I'd prefer to try any remaining troubleshooting steps before scheduling dealer service if there's anything else worth attempting.
Thanks in advance!
Sponsored
