Rear Motor Mount

[ckone2030]

The mount isn’t quite symmetrical longwise. Is the PRL engraving pointing up or down?

I was trying to install it pointing up. I talked with PRL and I think my mistake was to trying to install it on an angle. I used a ramp to get the front elevated, so the advise is to also jack the back of the car so it is leveled. And as ZeroGSR said, try to jack the engine up if still not aligned. Unfortunately I won’t be able to try it again for another couple of weeks but will give an update once installation is complete (hopefully…fingers crossed).

Sponsored

 

[thosport]

I was trying to install it pointing up. I talked with PRL and I think my mistake was to trying to install it on an angle. I used a ramp to get the front elevated, so the advise is to also jack the back of the car so it is leveled. And as ZeroGSR said, try to jack the engine up if still not aligned. Unfortunately I won’t be able to try it again for another couple of weeks but will give an update once installation is complete (hopefully…fingers crossed).

If I remember correctly, logo pointing down matched the OEM mount geometry.