HGHVLTS' Integra Type S Build

[HGHVLTS]

Got the FL5 front seat belts installed, front are plug and play, rears not so much unfortunately.

Sponsored

 

[HGHVLTS]

Got a Radium PCV Air/Oil Separator, nice quality and easy install, hope it helps in the future.

 

[HGHVLTS]

Finally got to my Paragon upgrade! Front rotors for OEM hats, upgraded rears with hats, and Hawk Performance Ceramic Pads.

Rear difference!

 

[HGHVLTS]

Added OEM Type R shift knob and nut, wanted to match the seat belts!

Car wash totally gouged my bumper trim, was able to get replacement, $130 each. Wasn’t even sure they were painted, but can’t wait to get them on.

 

[HGHVLTS]

Finally got to replacing the lower vents and installed the Velossa Tech Designs ram air tubes as well as the PRL Carbon intake tube with JDC Titanium Emblem.

 

[UWU-mancer]

Do both air tubes direct air to the intake?

car looks great man

 

[HGHVLTS]

Do both air tubes direct air to the intake?

car looks great man

Thanks, Not really sure what the passenger side one does, guess it just vents air under the hood. Only the drivers side actually direct to the intake. I mainly got it for a little extra flair, doubt I’ll notice much with the “extra” air flow.

 

[egxflash]

Thanks, Not really sure what the passenger side one does, guess it just vents air under the hood. Only the drivers side actually direct to the intake. I mainly got it for a little extra flair, doubt I’ll notice much with the “extra” air flow.

probably for symmetry. Did you get the lights for it too?

 

[HGHVLTS]

probably for symmetry. Did you get the lights for it too?

figured that was the case but, no I didn’t get the lights for them. That was a little to gaudy for my tastes, I was already pushing it with the red rim.

Sponsored