Does this look ready to re clear?

[BlackDTeggy]

Took my oem spoiler off because it was peeling like many others. Went through a pain in the ass getting the spoiler off with the zip ties, and getting the tape off- want to make sure I’m doing this the best I can. I got a Bauer sander and 600 grit disc, also used scotch pad and got it as smooth as I can. The peeling spots feel slightly different like not as glossy, but not catching my nail on any transitions or anything.

Sponsored

 

[ModJPB]

Sand as little as possible. Trying to avoid scraping down to the carbon fibers. When a fiber is cut it will fray, lifting up making it impossible to get a smooth surface.

 

[BlackDTeggy]

I got it the best I could, and sprayed, waiting to Cure.
Did notice rust on the holes they drilled, they painted but not well enough. What should I do here?

 

[Frenzal]

Remove the rust (completely, you might need to remove a bit more paint), then touch up paint (let it dry), then anti-rust grease before installing the spoiler back.

Sponsored