Integra Type-S / A-Spec Tech Gauge Pod – Limited Run Announcement

[Revrend1993]

One part i am not following on the install of the gauges is after running the wires under the battery charger, when you put everything back together, where is the gap for the wires? I dont see where the wires can run without being able to put the center console back together. It seems like it would prevent some piece from snapping or screwing back in. Any clarity you can give me here or pics would be great

Sponsored

 

[jaypinto]

One part i am not following on the install of the gauges is after running the wires under the battery charger, when you put everything back together, where is the gap for the wires? I dont see where the wires can run without being able to put the center console back together. It seems like it would prevent some piece from snapping or screwing back in. Any clarity you can give me here or pics would be great

When i had them installed the tech fit the wires between two pieces of trim. I noticed that the wires were being bitten into by the trim so i made a notch in some of the trim to give it a bit of space

 

[justa335i]

One part i am not following on the install of the gauges is after running the wires under the battery charger, when you put everything back together, where is the gap for the wires? I dont see where the wires can run without being able to put the center console back together. It seems like it would prevent some piece from snapping or screwing back in. Any clarity you can give me here or pics would be great

Hey there!
IIRC there was one rear tab that wasnt locked in, but I dont remember.
I did the install and posted the guide when i was sick and thats the ONE PART that didnt have photos.

 

[maximetardif]

One part i am not following on the install of the gauges is after running the wires under the battery charger, when you put everything back together, where is the gap for the wires? I dont see where the wires can run without being able to put the center console back together. It seems like it would prevent some piece from snapping or screwing back in. Any clarity you can give me here or pics would be great

I know I'm late but I routed my wires by the hole for the LED light on top of the wireless charger. The light is no longer needed so I found this a good solution.

 

[Revrend1993]

I know I'm late but I routed my wires by the hole for the LED light on top of the wireless charger. The light is no longer needed so I found this a good solution.

This is great, how hard is it to pull that upper charge panel out? Anything I shoukd know on that

 

[maximetardif]

This is great, how hard is it to pull that upper charge panel out? Anything I shoukd know on that

Easy, the part is only clipped

 

[slowcountry]

What gauges did y'all go with?

I was looking at the Defi Advance RS II for oil temp and oil pressure yesterday, but hard to find a retailer that has them

 

[justa335i]

Link to STL:
https://makerworld.com/en/models/2788490-de5-integra-fl5-civic-gauge-pod#profileId-3100306

Sponsored