Installed CanFlex and now have P2122 code

[strtsol1109]

What's up guys, installed a new Hondata Canflex this past week and uploaded a tune from my tuner and am getting a P2122 that I cannot get to go away.

Any help or ideas would be appreciated

Steps of fixes
-After initial install I realized i was on an older version on hondata that didn't have the beta update
-Updated and re-flashed
-Triple checked all pins/connections, unplugged and resat anything near where i worked.
-went over all pins etc on the actual pedal, no wires taught etc
-Re-flashed to my pre-canflex tune, still same code
-Back on canflex tune now, Im lost

The only thing i can think of i haven't tried yet is unhooking the canflex jumper to see if the impedance is in that wiring, but waiting on confirmation i can start the car on this tune with that unhooked with no issues.

Sponsored

 

[madchiller]

first thing i'd check is the connector to the accelerator pedal. unplug it and check the pins are corroded or bent for some reason. then reseat it well. second i'd check fuses. from there it's getting down and dirty with a voltmeter.

maybe you could just clear the code and see if it comes back if you havent tried that.

 

[mek]

Wait what does the pedal have to do with the canflex? Im i missing something? I just installed my canflex and didn't touch the pedals.

 

[strtsol1109]

It was a circuit code from my pedal sensor, they are not directly related, i was careless and clipped a wire when punching through the firewall gromet

Sponsored