tvs_1320
Member
- Thread starter
- #1
4x bolt on spacers with low profile nuts to bolt the spacers to the exiting studs, then the wheel bolts to the studs in the spacers. May require longer lug nuts (see other listing of mine if interested)
Ran these on my integra A-spec until I traded it.
Asking $45 plus shipping.
https://www.titanwheelaccessories.c...-5-studs-set-of-4?_pos=2&_fid=d8d190a42&_ss=c
They are in good shape, just not perfect. There is a tiny bit of surface rust on a few of the studs, but nothing bad. A lot of what you see is silver anti-sieze which is somewhat fused to the paint. Laquer thinner or something might get it off but I didn't bother for a face you won't see when mounted. Tried to get enough pictures to show you the condition they are in.
Word of warning -- the stock lugs are a little too long and stick out a bit too much to run these with the stock A-spec wheels unless you do a small amount of clearance-ing of the existing pockets in the wheels. I did mine and it was pretty easy to do with a dremel. The stock short Acorn lug nuts also are not long enough ( bottom out before getting tight) on the lugs that the titan spacers have installed with the stock A-spec wheels (2024 at least). I had to get longer acorn lug nuts - like the Gorilla ones I have listed (1.38" long vs something like 0.8" for the stock ones).
Jim
Ran these on my integra A-spec until I traded it.
Asking $45 plus shipping.
https://www.titanwheelaccessories.c...-5-studs-set-of-4?_pos=2&_fid=d8d190a42&_ss=c
They are in good shape, just not perfect. There is a tiny bit of surface rust on a few of the studs, but nothing bad. A lot of what you see is silver anti-sieze which is somewhat fused to the paint. Laquer thinner or something might get it off but I didn't bother for a face you won't see when mounted. Tried to get enough pictures to show you the condition they are in.
Word of warning -- the stock lugs are a little too long and stick out a bit too much to run these with the stock A-spec wheels unless you do a small amount of clearance-ing of the existing pockets in the wheels. I did mine and it was pretty easy to do with a dremel. The stock short Acorn lug nuts also are not long enough ( bottom out before getting tight) on the lugs that the titan spacers have installed with the stock A-spec wheels (2024 at least). I had to get longer acorn lug nuts - like the Gorilla ones I have listed (1.38" long vs something like 0.8" for the stock ones).
Jim
Sponsored
Last edited: